Linux PPTP VPN Setup

Step 1: Click on the configuration icon.

Step 2: Click Network.

Step 3: Click the plus sign in the lower left corner of the network panel.

Step 4: Add a new VPN interface and click Create.

Step 5: Select PPTP as the VPN type and click Create.

Step 6: Edit the parameters of the connection as seen below. The gateway is one of the server names that you can find in your setup email or find them on our support homepage. Scroll to the bottom of the profile page to see all available server names and locations.

The username is your Unblockmytelly VPN username  and the password is the same password that you selected when you signed up for our service.

Click Advanced

Step 7: Enable MPPE to make sure that the connection is encrypted. This is an optional step however. Encryption will casue a 5-25% performance loss depending on your computer and network connection. If the VPN is used mainly for online media streaming, you may leave this off.

Click OK

Step 8: Click Save.

Step 9: If you want to save your password, you may be prompted for your keyring password. Unless set up differently, this is your root password by default.

Click OK

Step 10: Slide the VPN switch to the ON position to connect. To disconnect, slide it to OFF.

Step 11: That’s it you should now be connected to the VPN.

Enjoy, Connect, Unblock, watch TV